Wincor Nixdorf BEETLE AT COM Board Guía de usuario descargar pdf (Pagina 11)

Installation in the BEETLE /60, BEETLE /L

Install the COM board in a free slot of your BEETLE POS system. Refer to

the documentation of your POS system (chapter on installing an expansion

card).

Installation in the BEETLE /M

When installing the At COM board please proceed as described in the

manual “BEETLE /M”, chapter “AT plug-in card”.

Insert the complete shell with the COM7/COM8 interfaces from outside into

the backplane. Therefore, the vertical situated cover (1) has to be cracked

out of the back plane before.

Now push the connectors through into the BEETLE /M and then the shell (2)

can be put with its bended side in the back plane. Secure the shell with the

screws. Connect the connector to the AT COM board as shown in the

illustration on page 2.

INSTALLATION IN THE BEETLE /60, BEETLE /L

(1)

(2)

(3)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Sin comentarios

Wincor Nixdorf BEETLE AT COM Board Guía de usuario Pagina 11